FRAME: CarbonCore Hexacopter 650mm
(Comes with 1 Frame)

Shown with upgraded Aluminum Anodized Screws & CF Props

Shown with upgraded Aluminum Anodized Screws & CF Props

Frame: 1.5mm Carbon Fibre
Landing Legs: 2.0mm Carbon Fibre
Landing Skids: 2.0mm Carbon Fibre
Motor Center Diameter: 650mm

The virtual pictures show a solid black finish to the frames however these multicopters have a Woven Carbon Fibre finsh

CarbonCore Carbon Fibre used in this product now has an even shine on both sides

Motor Arms can be folded to make the frame much more compact for transport - Picture will be added

The Hexacopter offers the highest stability at the best price

Recommended for use with the Mini Radius Camera Mount for aerial photography

Multicopters currently do not have display packaging

FLIGHT CONTROLLER: DJI Wookong-M Multirotor Stabilization Controller
(Comes w/1 Flight Controller)

DJI Wookong Multi-Rotor stabilization controller is a complete flight system for all multi-rotor platforms for commercial and industrial AP applications. Unlike others, WooKong allows the use of regular ESC commonly used in RC helicopter without any wiring modification; Heli mode setup providing a seamless transition for current Ace One AP professionals. WK-M utilizes high quality components precisely calibrated with temperature compensation in all gyros and sensors, industry renounce flight algorithm in autopilot and UAV. IMU damping system is rated for gas engine best in the class.

Attitude mode maintains precise altitude hold for indoor flight while GPS mode provides superb position hold outdoor. External LED flight mode indicator light can easily be observed by pilots under any condition.

WK-M can be flown in one single full auto (GPS-Atti) mode from take-off to landing; or in Atti mode while manual mode has stabilization activated. The system is easy to install with user friendly software allowing on-line firmware and software upgrade.

FEATURES:
GPS (inclusive) Position, Altitude hold and Heading hold
Attitude mode using accurate barometer sensor for altitude hold
Use regular over the counter ESC
Three flight modes – manual, Attitude and GPS Attitude
Fail Safe Hover
Go Home & Auto Landing
Hex-Rotor support
Octo-Rotor support
Voltage Monitor
Power Module
D-Bus Support
Arm Mode
Provides two options to stop motors
Import/Export functions

TECH SPEC

General specifications
Built-In Functions:	Autopilot
	Auto Hover Fail Safe
Multi Rotor Types:	Quad-Rotor
	Hex-Rotor
	Octo-Rotor
Supported ESC output:	400Hz refresh frequencys
Recommended Transmitter:	PCM or 2.4GHz with minimum 5 channels and Failsafe function available on all channels
Recommended Power Supply:	DC 4.8 ~ 12V
Power Consumption:	MAX 5W
	(0.9A@5V, 0.7A@5.8V,0.5A@7.4V,0.4A@8V)
Operating Temperature:	-5°C to +60°
	(You have to keep the IMU warm if you want to use it under low temperature, could be -5°Cor lower.)
Flight Performance (can be effect by mechanical performance)
Hovering Accuracy:	Vertical	0.5m
	Horizontal	2m
Suitable Wind Condition:	< 8m/s (17.7mph)
Max Rotate Angle:	30 degrees
Vertical Speed:	3m/s
Packaging &Shapes
Total Weight:	<= 150g
Dimensions:	Main Controller:	51mm x 39.6mm x 15.8mm
	IMU:	40mm x 31mm x 26mm
	GPS & Compass:	50mm (diameter) x 9mm
	LED Indicator:	25mm x 25mm x 7mm

MOTOR: Avroto M2814-11S Short Shaft 770KV Brushless Motor
(Comes w/6 Motors)

Avrot is a high quality, smooth running, durable brushless motor built for multirotor UAV applications. The custom assembly methods,reinforcements, and components unique to Avroto motors help to provide the reliability required for a dependable aerial platform.

Model number M2814-11S:

Weight approximately 100 grams not including wires
External Dimensions 35mm D x 36mm L
Stator Dimensions 28mm D x 14mm L
Internal Shaft diameter 4mm
Prop Adapter diameter 6mm
No-load speed: 770 rpm / V
Ri (Internal Resistance) 100m
Io (no load current) 0.5A
Voltage for Io measurement 10V
Current capacity 25A/180s
Watts: 350
Lipo cell 3-4
Wire length 600mm
14magnets 12 stator arms 12N 14P

Shaft secured by snap ring

.2mm NdFeB sheet
Hardened shaft from Japan
Quality EZO brand bearings from Japan
High quality accessories included
Includes radial mount set with prop adapter

Test results from sample M2814-11 motors courtesy of RCG member 13brv3
Avroto M2814-11
Prop	APC 10x4.7 SF	APC 11x4.7 SF	APC 12x3.8 SF
Max Watts @ 11.1V	122	163	201
Max Thrust Oz	30.4	39.3	46.3
Prop	APC 10x4.7 SF	APC 11x4.7 SF	APC 12x3.8 SF
Max Watts @ 14.8V	266	346	423
Max Thrust Oz	50.9	60	60.3

30A ESC: TURNIGY Plush 25amp Speed Controller
(Comes w/6 Speed Controllers)

The Plush series ESC are a very good quality controller. They have a broad range of programming features and a smooth throttle response compared to other BESCs in the same price range

Cont Current: 30A
Burst Current: 40A
BEC Mode: Linear
BEC : 5v/2A
Lipo Cells: 2-4
NiMH : 5-12
Weight: 25g
Size: 45x24x11mm

GRAUPNER ELEKTRO PROP propeller
(Comes w/3 Right Turn and 3 Left Turn Props)

A new series of propellers specially designed for electric power systems. These high-strength glass-reinforced plastic propellers feature exceptionally good torsional rigidity in spite of their ultra-thin, low-drag profile and high aspect ratio blades. For every propeller size there is an exactly matched counterpart for opposite rotation, which means that twin-motor model aircraft can easily be equipped with contra-rotating propellers. This makes take-off and launch of these models much safer, as the tendency for motor torque to stall the model or tip it onto one wingtip is suppressed.

Suitable for many models including the new HEINKEL HE 111, Order No.9594, and B-25 Mitchell, Order No.9373.

Specification

Diameter / Pitch: 25/12,5 cm
Diameter / Pitch (Inch): 10/5 "
Diameter / bore : 8 mm

Our price: $2600 Customer will be billed for shipping once build is complete Rc-Drones will cover packing, packing material